Check Wheels Manufacturing BB's, really smart design for PF frames.
| Dirt Treaders http://dirttreaders.com/phpBB3/ |
|
| BSA30 bearing puller and press tools? http://dirttreaders.com/phpBB3/viewtopic.php?f=9&t=17414 |
Page 1 of 1 |
| Author: | avidtest [ Thu Aug 24, 2017 7:19 am ] |
| Post subject: | BSA30 bearing puller and press tools? |
Any NC peeps have a set I could use? My Raceface BB bearings are crunchy and I'd prefer to replace the bearings only with better quality ones from RWC/Enduro rather than buying another RF BB with their less than ideal bearings. Otherwise, I'll probably buy new cups from Enduro w/ bearings already fitted. Obviously, much cheaper to just replace the bearings in the existing cups though. |
|
| Author: | OldDogDan [ Thu Aug 24, 2017 1:14 pm ] |
| Post subject: | Re: BSA30 bearing puller and press tools? |
I think in most cases you can get them out of the cups without a puller if you're careful and patient (one beer limit), but it's probably worth it to just buy the new cups & bearings from RWC Enduro to save the frustration. |
|
| Author: | 325racer [ Thu Aug 24, 2017 5:07 pm ] |
| Post subject: | Re: BSA30 bearing puller and press tools? |
Bring to Fluid Focus in San Marcos. He trued up my road wheels in a day and was very reasonably priced. If you had everything prepped, it would probably take about an hour if you scheduled an appointment. |
|
| Author: | avidtest [ Thu Aug 24, 2017 7:03 pm ] |
| Post subject: | Re: BSA30 bearing puller and press tools? |
Thanks. I think I can just tap them out with a screwdriver and hammer and insert with grease and a vise. It's worked for my other bearing replacements, so what the hey. |
|
| Author: | Dirtrider [ Thu Aug 24, 2017 8:49 pm ] |
| Post subject: | Re: BSA30 bearing puller and press tools? |
In the past I've "pressed it in" with a long bolt, spacers, and washers which worked fine. Just don't go too fast and make sure it's aligned |
|
| Author: | Belizean [ Fri Aug 25, 2017 9:03 pm ] |
| Post subject: | Re: BSA30 bearing puller and press tools? |
Check Wheels Manufacturing BB's, really smart design for PF frames.
|
|
| Author: | avidtest [ Sat Aug 26, 2017 6:40 am ] |
| Post subject: | Re: BSA30 bearing puller and press tools? |
Thanks Fred, but it's not press fit. Although, they do have nice threaded BB's too, which would have been the simple solution. However, I went ahead and ordered only the bearings from Wheels Manufacturing. And also a bearing puller and press tools as well. The vice is nice, but isn't always the best answer. I'll be glad to have those particular tools in the arsenal. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|