| Dirt Treaders http://dirttreaders.com/phpBB3/ |
|
| Pull out or leave it in rear... http://dirttreaders.com/phpBB3/viewtopic.php?f=9&t=16991 |
Page 1 of 1 |
| Author: | 406 [ Wed Aug 10, 2016 2:02 pm ] |
| Post subject: | Pull out or leave it in rear... |
tire?  Attachment: Screen Shot 2016-08-10 at 1.53.34 PM.png [ 653.57 KiB | Viewed 10242 times ] That is a nail bent over. Picked it up about 10 miles ago this morning and only lost a few psi before stans sealed. Prior to my 11 mile ride this afternoon, do I pull out and hope for a reseal or leave in and hope it doesn't wiggle? 
|
|
| Author: | Cyanide41 [ Wed Aug 10, 2016 2:56 pm ] |
| Post subject: | Re: Pull out or leave it in rear... |
Pull it out. It will either push in further or fall out eventually. It it happens on a ride, that would be a pain. |
|
| Author: | mtbchip [ Wed Aug 10, 2016 4:06 pm ] |
| Post subject: | Re: Pull out or leave it in rear... |
Patch from the inside. |
|
| Author: | 406 [ Wed Aug 10, 2016 4:12 pm ] |
| Post subject: | Re: Pull out or leave it in rear... |
right, but the question is: do i ride it home as is or remove prior to riding 11 miles to better tools/more stans. With only trail tools, I'm thinking leave it in. |
|
| Author: | ajdonner [ Wed Aug 10, 2016 6:15 pm ] |
| Post subject: | Re: Pull out or leave it in rear... |
I'd leave it in. So how'd it go? |
|
| Author: | OldDogDan [ Wed Aug 10, 2016 7:45 pm ] |
| Post subject: | Re: Pull out or leave it in rear... |
Ha ha! If you leave it in long enough it'll eventually slip out... On the trail, if I was confident I had plenty of fresh Stans (and a backup patch kit) I'd yank it out and spin the tire to help seal it. Might avoid further damage. If not confident, leave it in. Let us know how it went. |
|
| Author: | 406 [ Thu Aug 11, 2016 10:44 am ] |
| Post subject: | Re: Pull out or leave it in rear... |
Left it in and biked LPQ canyon gnar and didn't seem to drop any psi. Pulled out shortly after getting home, rather large nail, seems odd to have picked it up: Attachment: Screen Shot 2016-08-11 at 9.36.56 AM.png [ 386.22 KiB | Viewed 10177 times ] Spun wheel and stans seemed to reseal, so likely could have made it home if removed along the trail. I sure am a fan of tubeless.
|
|
| Author: | evdog [ Thu Aug 11, 2016 8:42 pm ] |
| Post subject: | Re: Pull out or leave it in rear... |
LOL at 406 getting nailed in the rear |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|