Dirt Treaders http://dirttreaders.com/phpBB3/ |
|
SS chain 1/2 link. http://dirttreaders.com/phpBB3/viewtopic.php?f=12&t=1700 |
Page 1 of 1 |
Author: | 02bullit [ Mon Feb 23, 2009 9:03 pm ] |
Post subject: | SS chain 1/2 link. |
Putting a new chain on my Frankenbike SS rebuild. Sized the chain up but its short by about a quarter link. I would rather have the tensioner pushing up instead of down. Anyone have a 1/8" chain half link or know where I can get one local. Pulse may have them later in the week. Just don't know if they are 1/8" or not. |
Author: | Brian [ Mon Feb 23, 2009 9:45 pm ] |
Post subject: | Re: SS chain 1/2 link. |
EDIT: Reread your post, just ask your lbs for a couple extra links they have laying around. Below are instructions if you decide to eliminate the tensioner. A half link will only add or shorten the chain by 1/2 inch. To shorten by 1/4 inch, you will most likely have to add two teeth somewhere. Here are is a link that may be helpful... Magic gear calculator http://www.eehouse.org/fixin/formfmu.php |
Author: | 02bullit [ Sat Feb 28, 2009 1:20 am ] |
Post subject: | Re: SS chain 1/2 link. |
I added another link but had to use 2 snap connectors so basically 2 more links. Was to long so I had to use the tensioner pushing down. Soulcraft recommends pushing up. I picked up a couple half links and it fits perfect. I can almost go without the tensioner. Thanks for the link for the magic gear calculator. |
Author: | ocd [ Wed May 13, 2009 8:33 am ] |
Post subject: | Re: SS chain 1/2 link. |
02bullit wrote: Putting a new chain on my Frankenbike SS rebuild. Sized the chain up but its short by about a quarter link. I would rather have the tensioner pushing up instead of down. Anyone have a 1/8" chain half link or know where I can get one local. Pulse may have them later in the week. Just don't know if they are 1/8" or not. If you have not gotten it yet, I've purchased them from Adams Ave bikes before. This was a couple of years ago but they had them. (unlike bicycle warehouse, whose folks insisted I had no idea what I was talking about and I must have mistaken a half link for a power link ) |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |