Crank arm for a SRAM S1000 for a 2x10 drive train?

tranceX · **Posted:** Tue Jan 27, 2015 4:10 pm

Looking for the crank arm for a SRAM S1000, 24/38 for a 2 x 10 drive train. Any ideas where to look?

It's for my Trance X2 29er. Thanks!
http://www.giant-bicycles.com/en-us/bik ... ifications

OldDogDan · **Posted:** Tue Jan 27, 2015 6:23 pm

There are some on EBay. Is there a bad crash story behind this?

Dirtrider · **Posted:** Tue Jan 27, 2015 6:52 pm

I think you can have your LBS order just one for you if needed.

AndYeti · **Posted:** Tue Jan 27, 2015 10:29 pm

I have an x9 2x10 that may fit the bill. I can check if you are interested.

Belizean · **Posted:** Wed Jan 28, 2015 8:30 am

AndYeti wrote:

I have an x9 2x10 that may fit the bill. I can check if you are interested.

That's a nice little upgrade and the rings would be compatible. :thumbsup:

tranceX · **Posted:** Wed Jan 28, 2015 10:13 am

How much for the x9? What size are the gears? I'm interested if its 24/38.

AndYeti · **Posted:** Wed Jan 28, 2015 4:50 pm

I'll dig it out of my parts bin later tonight and check the gearing and confirm if its what you need.

AndYeti · **Posted:** Wed Jan 28, 2015 11:50 pm

Sorry man, the gearing is 26/39.

Belizean · **Posted:** Thu Jan 29, 2015 9:54 am

Should be able to swap the chainrings out which will keep the chain/chainrings compatible, less likely to slip.

tranceX · **Posted:** Thu Jan 29, 2015 10:45 am

Ok, thanks, I'm going to pass. Thanks for looking for me. Hope it wasn't too much trouble.

AndYeti · **Posted:** Thu Jan 29, 2015 4:15 pm

It wasn't a problem.

Augdogg · **Posted:** Thu Jan 29, 2015 5:31 pm

Definitely, unless you are swapping out the chain too, I would be a good idea to mate it with existing chainrings. Easy to swap out.